In the Industrial Ethernet Protocols section of the dialog, select CC-Link IE Field Basic.From the Sensor menu, open the Network Settings dialog.Open In-Sight Explorer and connect to the desired In-Sight vision system.For more information on CC-Link IE Field Basic, refer to Mitsubishi's CC-Link IE Field Network Basic Reference Manual.To enable CC-Link IE Filed Basic from the EasyBuilder View, refer to the EasyBuilder Help (Communication > Device Setup > Communicating with Mitsubishi Devices > CC-Link IE Field Basic).
#Gx works 2 open .gpp file how to
This section describes how to connect to an In-Sight vision system using CC-Link communications to a Mitsubishi Q-Series Automation Controller. Configure In-Sight Vision Systems for CC-Link Protocol Communications Once the protocol is enabled and the vision system is configured in the controller, the controller will begin cyclic communications to the In-Sight vision system through a request/response mechanism. The data is mapped into controller memory through the Mitsubishi setup tools (GXWorks 2/3). The communications support 64 bits and 32 16-bit words of data per station in each direction, with each slave supporting 4 stations. As opposed to the existing SLMP (MC Protocol), the Mitsubishi automation controllers act as the master, driving the communications to the slave devices over standard UDP messaging. Communicate with a Mitsubishi Automation Controller on CC-Link IE Field Network BasicĬC-Link IE Field Basic is a protocol designed to integrate Ethernet devices into a Mitsubishi Automation Controller.